GORDON'S SPUDGUN PAGE

"THOUGH I WALK THROUGH THE VALLEY OF THE SHADOW OF DEATH, I SHALL FEAR NO EVIL... BECAUSE I AM THE BADDEST MOTHERFUCKER IN THE VALLEY!" ~ ANONYMOUS

THEORIES The following page is UNDER CONSTRUCTION and has various theories and construction details on cannons. USEING PROPANE C:B RATIOS BUILDING A BASIC COMBUSTOIN The following set of instruction will teach you how to build a basic combustion spudgun... MATERIALS 3" PVC pipe 3" female adapter and 3" coupling 3" htreaded plug 3" to 2" bushing reducer PVC glue 1" hole saw (could be smaller, it's all I had Matches HAIRSPRAY!!! INSTRUCTIONS Start off by cutting your 3" pipe to a 12" length. Glue the coupling and female adapter to both ends of the pipe. Glue the reducer into the coupling and thread the plug into the female adapter. Drill your 1" hole through the plug. Allow a FULL 2 HOURS to cure. Useing Jam your spud in the barrel and shove it down to the bottom... spray in your hairspray into the hole in the cap... aim, hold a match to the hole (WEAR DISHWASHING GLOVES!!!!) and WHHOOF!!!! off the potato goes. A simple design, but I have easily gotten ranges going all the way out to 1/2 a mile with this setup... DO NOT UNDERESTIMATE ITS POWER!!! GO BACK HOME